MIDWEST TUBS Installation & Operational Instructions Manufactured by MidWest Tubs A Division of Spa World Corp. 5701 NW 35th Avenue ASME A112.19.7-2006 Miami, Florida 33142 ANSI-Z124.
INSTALLATION INSTRUCTIONS & OWNER’S MANUAL (Refer to individual model sheets for specifications) BEFORE BEGINNING INSTALLATION, CHECK THE FOLLOWING ITEMS AND READ THE INSTRUCTIONS CAREFULLY. CHECK ENTIRE UNIT FOR CONCEALED DAMAGE. If there is any damage, DO NOT INSTALL! Shipping damages must be reported to the carrier immediately. All damage must be discovered and reported prior to installation in order to have it covered under the warranty! COMPARE COLOR OF UNIT WITH OTHER FIXTURES.
GENERAL NOTES READ AND FOLLOW ALL INSTRUCTIONS 1. 6. A green colored terminal (or a wire connector marked `G’, `GR’, `GROUND’, or `GROUNDING’) is provided within the terminal compartment. To reduce the risk of electrical shock. connect this terminal or connector to the grounding terminal of your electrical service or supply panel with a continuous green insulated copper wire equivalent in size to the circuit conductors supplying the equipment. but no smaller than No.10 AWE (5.
INSTALLATION INSTALLING ONE-PIECE SKIRT INSTALLATION CONTINUED TOUCH PAD (Option) PLUMBING ROUGH-IN The bath waste opening protrudes below the base approximately one inch. You may be required to cut a hole in the subfloor to accommodate bath waste. In slab on grade or prestressed concrete floors where cutting is not desired, the tub may be raised up by building the platform higher and using extra mortar under the tub. If a joist must be notched, verify that structure will not be weakened.
INSTALLATION INSTALLATION CONTINUED TYPICAL INSTALLATIONS Make absolutely certain that access panels and/or service openings are properly placed and that all possible areas where service may be required are accessible. CONTINUED CENTER ACCESS SKIRT Custom fitted skirt ensembles are available to provide the perfect finish for your bath and bathroom. All five (5) foot and six (6) foot rectangular models can be fitted with a one or two piece (center access) removable front skirt.
INSTALLATION INSTALLATION CONTINUED CONTINUED Air Button Control-Whirlpool or Optional Combo Air Controls Allows user to adjust the pressure from the jets. H.E.E.T. Maintains water temperature without a heater using kinetic energy of the water pump. Chromatherapy Star Jet Builder’s Jet Touch Pad E-Z Clean™ Safety Suction Air Control/Turbo Boost™ Aromatherapy O3 OZone™ An O3 ozonator is an automatic device that produces ozone to safely and effectively sanitize your bath while in use.
USER MAINTENANCE USER SHOULD periodically flush operating system (not to exceed 90 days). As a minimum, shall consist of filling and running system and draining. MidWest Tubs recommends flushing with a mild solution of water and sanitizer such as chlorine or other commercially available whirlpool bath flushing products. DO NOT use abrasives. They may dull or scratch surface of the acrylic. DO NOT use oil based solvents. Clean with only a damp cloth or mild detergent or any common glass cleaner.
NOTES 12
IMPORTANT: READ AND SAVE THESE INSTRUCTIONS. INSTALLER: SAVE INSTALLATION INSTRUCTIONS WITH HOMEOWNER HOMEOWNER: KEEP INSTALLATION INSTRUCTIONS FOR FUTURE REFERENCE Please leave owner’s manual with warranty. If you have any problems or questions during installation, please call technical service at 888-260-0993 Record the numbers here for handy reference: Model No. Serial No. Date of Purchase M a de in USA Manufactured by MidWest Tubs A Division of Spa World Corp.
