User manual
H.264 Network Digital Video Recorder User Manual
30
The concrete operation,please refer to the chapter of "3.5.1 Record Mode."
4.3 Record Config
Set the recording parameters in the surveillance channel. The system is set 24 hours consecutive recording in
the first startup. You can enter [main menu]> [recording config] to set.
NoteThere is at least one read-write hard disk.Detail operation please refer to chapter 4.5 HDD manage
Picture 4.1 Record config
channelChoose the corresponding channel number to set the channel. Choose the all option to set the
entire channels.
redundancyChoose the redundancy function option to implement the file double backup function. Double
backup is writing the video files in two hard disks. When you do the double backup, make sure that there
are two hard disks installed. One is read-write disk and the other is redundant disk. (refer to 4.5)
lengthSet the time length of each video file. 60minutes is default value.
pre-recordingRecord 1-30 seconds before the action. (time length is decided by the code stream)
recording controlSet video state: configuration, all or stop.
configuration
Record according to the set video type (common, detection and alarm)and time section.
all
Click the all button and the according channel is recording no matter the channel in any state.
stop
Click the stop button and the according channel stops recording no matter the channel in any state.
time sectionSet the time section of common recording, The recording will start only in the set range.
recording typeSet recording type: regular, detection or alarm.
regular
Perform the regular recording in the set time section. The video file type is “R”.
detection
Trigger the “motion detect”, “camera mask” or “video loss” signal. When above alarm is