Operation Manual

Temperature in 1 °C increments from cold, 30 to
max. 80 °C .
^
Turn the rotary dial to select the "Temperature" field
(70 °C for drying) and press it to confirm your
selection.
2 Cottons dry 13.0 kg
0 % Drying 70°C
Cooling down e
m A
^
Turn the rotary dial to alter the temperature value
and then press it to confirm your selection.
Residual moisture in
1 % increments from -4 to 40 % .
^
Turn the rotary dial to select the "Residual moisture"
field (0 %) and press it to confirm your selection.
2 Cottons dry 13.0 kg
0% Drying 70°C
Cooling down
m A
^ Turn the rotary dial to alter the residual moisture
level and then press it to confirm your selection.
^ Press the Start button and the programme selected
will commence
Once a programme has started the programme
sequence will appear in the display.
2 Cottons dry
0 % Drying >40 %{
Cooling down Ready at 12:35
mKf
In the 2nd line of the display, drying in this example,
the actual residual moisture level (>40%) and the
symbol for { heating switched on will also be shown.
The 3rd line displays the following programme block.
The time that the programme will finish (12:35) is
shown on the right hand side of the display.
The programme end display has a self-learning
function and will not show an accurate reading until
the programme has been run several times.
At the end of a programme
2 Cottons dry
Programme finished
Anti-crease Ready at 12:35
m FC Kf
The programme end time is displayed, the buzzer
sounds and the anti-crease phase commences. The
drum will rotate at intervals to keep the laundry from
creasing.
This is useful if laundry is not going to be unloaded as
soon as the programme finishes.
^
Open the drum door.
^
Unload the drum.
Make sure nothing is left behind in the drum. If
items are left in the dryer, they could be damaged
by overdrying when the dryer is next used.
,
Do not unload laundry from the drum until after
the cooling down phase has been completed.
Hot laundry can self-ignite and cause a fire when
folded or put away.
^ Check the fluff / lint filter and clean if necessary.
2 Cottons dry
Programme finished
Check lint filter
A
A reminder will appear in the display when the filter
needs to be cleaned. The filter should be cleaned as
soon as the programme finishes.
If the message continues to show in the display after
you have cleaned the filter, check the heat exchanger
behind the maintenance panel at the rear. Clean the
heat exchanger, if necessary (see "Cleaning and
care").
If no more laundry is to be processed:
^
Close the drum door
^
Press the 0 "Off" button to switch the machine off.
^
Switch off the on-site mains switch.
Drying
14