Operation Manual

With delay start you can choose when
you want the programme to end. The
start of a programme can be delayed
from 30 minutes up to a maximum of 24
hours, allowing you to make use of
night- time economy electricity rates,
for example.
The current time of day needs to
have been set for delay start to work
correctly.
If you have selected the "No time
displayed" option under Settings/
Supervisor level/Time of day, the start
time for a programme can be
delayed by up to 96 hours.
To select delay start
^ Select the programme you want and
then press the m button.
7:51
Start:
7:51
Finish:
9:19
The display shows the current time of
day and the time the programme is due
to finish.
7:51
Start:
10:32
Finish:
12:00
^
Use the + button to select the time
you want the programme to finish at.
The first press on the button will adjust
the finish time to the next full or half
hour. Each subsequent press on the
button will delay the finish time by 30
minutes.
Use the – button to shorten the time if
you have chosen too long a time.
^
Confirm the finish time by pressing
the OK button.
To begin delay start
^
Press the Start button.
60°C 1200 rpm
Start in: 2:41 h
The display will show how many hours
and minutes are left until the
programme start time.
To alter delay start
^ Press the m button.
^ Use the + and – buttons to alter the
time you want the programme to
finish at.
^ Press the OK button to confirm.
To cancel delay start
^
Press the m button.
^
Use the – button to bring the finish
time of the programme forward until
the programme start time is the same
as the current time of day.
^
Press the OK button to confirm.
The programme will now start immedi
-
ately.
The actual load size can only be
determined accurately by the
machine once the programme has
started. The programme end time
may, therefore, be a bit earlier than
first indicated.
Delay start
22