Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Saving energy
- Guide to the appliance
- Accessories
- Before using for the first time
- Switching on and off
- The correct temperature
- Using Super freeze
- Temperature and door alarm
- Selecting further settings
- Settings overview
- Selecting further settings
- Explanation of the different Settings
- Using the minute minder (QuickCool timer)
- – Setting the minute minder
- – When the minute minder duration has elapsed
- – Altering a minute minder entry
- – Cancelling a minute minder duration
- Switching the ice cube maker on and off
- – Additional functions
- Switching the ice cube maker off for a long time.
- Activating or deactivating the safety lock
- – Deactivating the safety lock temporarily
- – Deactivating the safety lock
- Switching the refrigeration appliance off
- Switching Sabbath mode on/off
- – Switching Sabbath mode on
- – Switching Sabbath mode off prematurely
- Setting the time before the door alarm is triggered
- Switching the sensor tone on / off
- Setting the volume/Switching alarms and audible tones on/off
- Setting the display brightness
- Setting the temperature unit /
- Switching Demo mode off
- Resetting to the factory default settings
- Accessing information
- – Displaying licence agreements
- Clean ventilation grille reminder
- Freezing and storing food
- Automatic defrosting
- Cleaning and care
- Problem solving guide
- Noises
- Service
- Installation
- Installation
- Climate range
- Ventilation
- Fitting supplied wall spacers
- Limiting the opening angle of the appliance door
- Fitting the door opening angle limiter
- – Removing the soft-close mechanism
- – Fitting the door opening angle limiter
- – Fitting the soft-close mechanism
- Installing the refrigeration appliance
- Aligning the appliance
- Levelling the appliance door
- Installing the appliance in a run of kitchen units
- Appliance dimensions
- Installing in a side-by-side combination
- Changing the door hinging
- Preparing to change the door hinging
- Removing the top covers
- Removing the soft-close mechanism
- Removing the appliance door
- Changing the lower hinge plate over
- Changing the upper door hinge over
- Preparing the appliance door
- Change the door opening aid over
- Changing the soft-close mechanism over
- Fit the bearing bush supplied into the upper appliance door
- Changing over the bearing bush stopper
- Refitting the appliance door
- Securing the soft-close mechanism
- Fitting the upper covers
- Aligning the appliance doors
- Mains water connection
- Electrical connection
- Installation
Switching on and off
24
Touch display
Using pointed or sharp objects on
the touch display can damage it.
Only touch the display with your fin-
gers.
If your fingers are cold, the touch dis-
play may not react.
Switching the appliance on
To enable the temperature to get suffi-
ciently cold inside the appliance, allow
the appliance to run for approx.
4hours before placing food in it.
Do not place food in the freezer until it
has reached the required coldness (at
least -18°C).
Standby
Touch briefly.
The welcome message
Miele - Willkommen will appear in the dis-
play for approx. 3seconds.
If this does not happen and ap-
pears in the display, the safety lock is
still activated (see “Selecting further
settings” - “Activating or deactivating
the safety lock” - “Deactivating the
safety lock temporarily”).
°C
-18
Start screen
The display changes to the start screen.
The interior light comes on. The appli-
ance is now switched on and will start
to cool. It will gradually reach the pre-
set temperature of -18°C.