Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Saving energy
- Guide to the appliance
- Accessories
- Before using for the first time
- Switching on and off
- The correct temperature
- Using Super freeze
- Temperature and door alarm
- Selecting further settings
- Settings overview
- Selecting further settings
- Explanation of the different Settings
- Using the minute minder (QuickCool timer)
- – Setting the minute minder
- – When the minute minder duration has elapsed
- – Altering a minute minder entry
- – Cancelling a minute minder duration
- Switching the ice cube maker on and off
- – Additional functions
- Switching the ice cube maker off for a long time.
- Activating or deactivating the safety lock
- – Deactivating the safety lock temporarily
- – Deactivating the safety lock
- Switching the refrigeration appliance off
- Switching Sabbath mode on/off
- – Switching Sabbath mode on
- – Switching Sabbath mode off prematurely
- Setting the time before the door alarm is triggered
- Switching the sensor tone on / off
- Setting the volume/Switching alarms and audible tones on/off
- Setting the display brightness
- Setting the temperature unit /
- Switching Demo mode off
- Resetting to the factory default settings
- Accessing information
- – Displaying licence agreements
- Clean ventilation grille reminder
- Freezing and storing food
- Automatic defrosting
- Cleaning and care
- Problem solving guide
- Noises
- Service
- Installation
- Installation
- Climate range
- Ventilation
- Fitting supplied wall spacers
- Limiting the opening angle of the appliance door
- Fitting the door opening angle limiter
- – Removing the soft-close mechanism
- – Fitting the door opening angle limiter
- – Fitting the soft-close mechanism
- Installing the refrigeration appliance
- Aligning the appliance
- Levelling the appliance door
- Installing the appliance in a run of kitchen units
- Appliance dimensions
- Installing in a side-by-side combination
- Changing the door hinging
- Preparing to change the door hinging
- Removing the top covers
- Removing the soft-close mechanism
- Removing the appliance door
- Changing the lower hinge plate over
- Changing the upper door hinge over
- Preparing the appliance door
- Change the door opening aid over
- Changing the soft-close mechanism over
- Fit the bearing bush supplied into the upper appliance door
- Changing over the bearing bush stopper
- Refitting the appliance door
- Securing the soft-close mechanism
- Fitting the upper covers
- Aligning the appliance doors
- Mains water connection
- Electrical connection
- Installation
Selecting further settings
34
Selecting further settings
In Settings mode, certain settings
can be adjusted and functions selected,
allowing you to adjust the refrigeration
appliance to suit your requirements.
See the following pages for more in-
formation on these settings.
The door alarm and other warnings
are automatically supressed when you
are in Settings mode. No symbol will
be displayed and no alarm will sound.
Exception: If there is an appliance fault
(F+numbers), Settings mode will be
exited automatically. The fault code
will be shown on the display and an
alarm will sound (see “Problem solving
guide – Display messages”).
Accessing Settings mode
°C
-18
Status display
Touch.
Settings mode
Scroll left or right using
theorarrow buttons.
The symbol for the selectable setting
appears in the middle of the display.
The symbols for the next available set-
tings appear in the background to the
right and left, but are not selectable.
Touch the symbol for the setting you
want (see “Settings overview”).
Depending on the setting selected,
there are two options:
1. You go into a sub-menu with further
options or where values can be
entered.
2. You select the setting directly. The
symbol turns orange and this con-
firms your selection. If the symbol is
white, the function has not been ac-
tivated.