Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Saving energy
- Guide to the appliance
- Accessories
- Before using for the first time
- Switching on and off
- The correct temperature
- Using Super freeze
- Temperature and door alarm
- Selecting further settings
- Settings overview
- Selecting further settings
- Explanation of the different Settings
- Using the minute minder (QuickCool timer)
- – Setting the minute minder
- – When the minute minder duration has elapsed
- – Altering a minute minder entry
- – Cancelling a minute minder duration
- Switching the ice cube maker on and off
- – Additional functions
- Switching the ice cube maker off for a long time.
- Activating or deactivating the safety lock
- – Deactivating the safety lock temporarily
- – Deactivating the safety lock
- Switching the refrigeration appliance off
- Switching Sabbath mode on/off
- – Switching Sabbath mode on
- – Switching Sabbath mode off prematurely
- Setting the time before the door alarm is triggered
- Switching the sensor tone on / off
- Setting the volume/Switching alarms and audible tones on/off
- Setting the display brightness
- Setting the temperature unit /
- Switching Demo mode off
- Resetting to the factory default settings
- Accessing information
- – Displaying licence agreements
- Clean ventilation grille reminder
- Freezing and storing food
- Automatic defrosting
- Cleaning and care
- Problem solving guide
- Noises
- Service
- Installation
- Installation
- Climate range
- Ventilation
- Fitting supplied wall spacers
- Limiting the opening angle of the appliance door
- Fitting the door opening angle limiter
- – Removing the soft-close mechanism
- – Fitting the door opening angle limiter
- – Fitting the soft-close mechanism
- Installing the refrigeration appliance
- Aligning the appliance
- Levelling the appliance door
- Installing the appliance in a run of kitchen units
- Appliance dimensions
- Installing in a side-by-side combination
- Changing the door hinging
- Preparing to change the door hinging
- Removing the top covers
- Removing the soft-close mechanism
- Removing the appliance door
- Changing the lower hinge plate over
- Changing the upper door hinge over
- Preparing the appliance door
- Change the door opening aid over
- Changing the soft-close mechanism over
- Fit the bearing bush supplied into the upper appliance door
- Changing over the bearing bush stopper
- Refitting the appliance door
- Securing the soft-close mechanism
- Fitting the upper covers
- Aligning the appliance doors
- Mains water connection
- Electrical connection
- Installation
Cleaning and care
53
Preparing the refrigeration ap-
pliance for cleaning
Switch the refrigeration appliance off.
appears in the display and cooling is
switched off.
Take any food out of the refrigeration
appliance and store it in a cool place.
Take out the freezer drawers and
glass plates.
Pull the trim off the right and left hand
sides of the top glass plate.
Removing the telescopic runners
To remove the telescopic runners:
1. Push the catch upwards.
2. Push the telescopic runner to the
side.
3. Then pull the telescopic runner off to
the rear.
After cleaning, reattach the telescopic
runners to the shelf.
1. Do so by hooking the telescopic run-
ner on at the rear.
2. Then clip the catches into position at
the front.
Take out all other removable parts for
cleaning.