User manual

The correct temperature
41
Temperature display
In normal operation, the temperature
display shows the current average
refrigerator section temperature and
the maximum freezer section tem-
perature.
Depending on the ambient temperature
and the temperature setting, it can take
the appliance a few hours to reach the
temperature required and for this tem-
perature to then be shown as a con-
stant temperature on the display.
Setting the temperature in the
refrigerator/freezer sections
 Touch the OKsensor control on the
control panel.
 will appear in the display (refrigerator
section is selected).
 Use the andsensor controls to
change the selected temperature
zone if required.
 TouchOK.
 Use the andsensor controls to
change the temperature.
 TouchOK.
The temperature display will then
change back to the current temperature
in the relevant temperature zone.
Possible temperature settings
- Refrigerator section: 2to9°C
- Freezer section: -15to-26°C
If you change the temperature set-
ting:
 check the temperature display after a
few hours. It will take this long for the
appliance to give an accurate read-
ing.
- Wait for approx.6hours if the refri-
geration appliance is not very full
- Wait for approx.24hours if the refri-
geration appliance is full
If, after this time, the temperature is still
too high or too low:
 Adjust the temperature again.