User manual

Selecting further settings
52
Resetting the settings to their default
settings
All settings made on the refrigeration
appliance will be reset to default set-
tings (for settings, see “Guide to the ap-
pliance”).
 In Settings mode, use the or
sensor control to scroll to the
symbol.
 Touch OK.
 Use the sensor control to scroll to
the symbol.
 Touch OK.
The refrigeration appliance switches off
and must be switched on again.
Information
Appliance data (model identifier and
serial number) is shown on the display.
Keep this appliance data to hand:
- For integrating the refrigeration appli-
ance into your WiFi network (see “Se-
lecting further settings –
Miele@home”).
- When reporting an appliance fault to
the Miele Customer Service Depart-
ment (see “Service”).
- When retrieving information from the
EPREL database (see “Service”).
Charcoal filter change indicator
After inserting the charcoal filter (op-
tional accessory), you must activate the
charcoal filter change indicator in
Settings mode.
The charcoal filter change indicator
on the start display will remind you to
replace the charcoal filter approx.
every 6months (see “Cleaning and
care – Replacing the charcoal filters”).
Cleaning mode
Cleaning mode makes it easier to
clean the fridge zone (see “Cleaning
and care”). The interior lighting re-
mains switched on, even though the
fridge zone is switched off. The buzzer
will stop and the symbols on the dis-
play will also go out.
If Cleaning mode is switched on,
this will be indicated on the start dis-
play.
After cleaning, Cleaning mode must
be switched off. If the appliance door is
closed for more than 10minutes,
Cleaning mode switches itself off
automatically.