Operating and Installation instructions

Switching on and off
23
Before first use
Packaging material
 Remove all packaging material from
the inside of the appliance.
Cleaning the refrigerator
Please refer to the relevant instruc-
tions in “Cleaning and care”.
 Clean the inside of the appliance and
the accessories.
Allow the appliance to stand for ap-
prox. 1hour prior to connecting it to
the power supply.
This will help prevent any malfunc-
tions.
Operating the appliance
A light touch of the finger on the sen-
sors is all that is required to operate this
appliance.
Switching the appliance on
The refrigerator and freezer sections
are separately controlled and can be
turned on and off so that only one
section is in use if necessary This is
useful, e.g. while on vacation if you
only want the freezer section to remain
on.
 Touch the sensor to switch the refrig-
erator or freezer section on or off, so
that the relevant temperature appears
in the display.
The appliance will start cooling.
The interior lighting will come on when
the refrigerator section door or a freezer
drawer is opened.
The temperature in the refrigerator sec-
tion is shown in the top of the display
and the temperature in the freezer sec-
tion is shown in the bottom of the dis-
play.
If the temperature in the freezer sec-
tion is not within the normal tempera-
ture display range (below 32°F / 0°C),
dashes will flash in the display.
The alarm symbol will also flash in
the control panel until the selected
temperature has been reached.
To enable the temperature to get suf-
ficiently cold inside the appliance, al-
low the appliance to run for a few
hours before placing food in it. Do
not place food in the freezer until the
temperature is at least 0°F (-18°C).