Operating and Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Saving energy
- Guide to the appliance
- Switching on and off
- The correct temperature
- Using Automatic SuperCool and SuperFreeze
- Selecting additional settings
- Temperature and door alarm
- Storing food in the refrigerator section
- Storing food in the PerfectFresh zone
- Adjusting the interior fittings (refrigerator section)
- Adjusting the interior fittings (freezer section)
- Freezing and storing food
- Making ice cubes
- Automatic defrosting
- Cleaning and care
- Frequently asked questions
- Causes of noises
- Service and warranty
- Water connection
- Electrical connection
- Installation information
- Installation and appliance dimensions
- Building in the appliance
- Before installing the appliance
- Preparing the niche
- Securing the covers
- Pushing the appliance into the niche
- Aligning the appliance
- Aligning the freezer drawer fronts
- Securing the appliance in the niche
- Remove the fixing bracket
- Fixing the fixing brackets to the cabinet doors
- Securing the cabinet fronts to the freezer drawers
- Securing the cabinet door to the refrigerator door
- Fitting the air filter and ventilation grille
Switching on and off
24
Switching the appliance off
To switch the refrigerator or freezer
section on or off touch the sensor un-
til the relevant temperature display
goes out in the display.
If this cannot be done, the safety lock
is activated. The symbol will ap-
pear in the control panel.
The interior lighting goes out and cool-
ing is turned off.
Turning off for longer periods
of time -
Vacation mode
If, during a long absence, the ap-
pliance is switched off but not
cleaned and the door(s) left shut,
there is a danger of bacteria building
up inside the appliance.
It is essential to clean the appliance.
If the appliance is not going to be used
for a longer period of time, e.g. whilst
on vacation:
close the water shut-off valve.
If the indicator light for the ice cube
maker begins to flash, this means
that there is still water remaining in the
ice cube maker.
Leave the ice cube maker turned on
for another day so that the remaining
ice cubes can be produced.
When all remaining ice cubes have
been produced, touch the On/Off
sensor for the ice cube maker so that
the indicator light for the ice cube
maker goes out in the right-hand
side of the display.
If you are going to be away for longer
than a month, please also:
remove and dispose of the remaining
ice cubes from the ice cube con-
tainer,
take any food out of the appliance
and store it in a cool place,
switch the appliance off,
unplug the power cord or trip the cir-
cuit breaker,
clean the appliance (see “Cleaning
and care”),
leave the door(s) ajar to air the appli-
ance and avoid odors building up in-
side the appliance.