Operating and Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Saving energy
- Guide to the appliance
- Switching on and off
- The correct temperature
- Using Automatic SuperCool and SuperFreeze
- Selecting additional settings
- Temperature and door alarm
- Storing food in the refrigerator section
- Storing food in the PerfectFresh zone
- Adjusting the interior fittings (refrigerator section)
- Adjusting the interior fittings (freezer section)
- Freezing and storing food
- Making ice cubes
- Automatic defrosting
- Cleaning and care
- Frequently asked questions
- Causes of noises
- Service and warranty
- Water connection
- Electrical connection
- Installation information
- Installation and appliance dimensions
- Building in the appliance
- Before installing the appliance
- Preparing the niche
- Securing the covers
- Pushing the appliance into the niche
- Aligning the appliance
- Aligning the freezer drawer fronts
- Securing the appliance in the niche
- Remove the fixing bracket
- Fixing the fixing brackets to the cabinet doors
- Securing the cabinet fronts to the freezer drawers
- Securing the cabinet door to the refrigerator door
- Fitting the air filter and ventilation grille
Selecting additional settings
36
The last selected setting lights up in the
display.
By touching the sensors for setting
the temperature in the freezer section
you can alter the brightness of the
temperature display between and
.
Touch the Super sensor again to save
the setting.
Touch the on and off sensor for the
freezer section to exit Settings mode.
Changing the door seal heater
setting
If condensation builds up on the door
seal for the refrigerator section doors,
this can be eliminated by selecting the
highest door seal heater setting ( ).
The factory default is (middle set-
ting).
Condensation will not usually form at
an average ambient temperature and
humidity.
If condensation should form on the
door seal at higher air humidity and a
lower ambient temperature, set the
door seal heater temperature to the
highest level.
Touch the On/Off sensor for the Su-
perFreeze function for approx. 5sec-
onds.
The indicator light in the right-hand
side of the display will light up at this
time and after approx. 5seconds S will
flash in the bottom (freezer section)
temperature display. MENU will light up
in the display. You are now in Settings
mode.