User manual

The correct temperature
41
Temperature display
In normal operation, the temperature
display shows the current average
refrigerator section temperature in-
side the refrigeration appliance.
Depending on the ambient temperature
and the temperature setting, it can take
the appliance a few hours to reach the
temperature required and for this tem-
perature to then be shown as a con-
stant temperature on the display.
Setting the temperature
 Touch the temperature display on the
display.
 Swipe left or right until the temperat-
ure you want is shown in the middle.
 Tap on the temperature you want to
confirm.
The temperature display will then
change back to the current temperature
in the refrigeration appliance.
Possible temperature settings
- Refrigerator section: 3to9°C
Adjusting the PerfectFresh Active
zone temperature
The temperature in the PerfectFresh
Active zone is automatically maintained
between 0and3°C.
However, if you would like it to be
warmer or colder, e.g. when storing
fish, you can adjust the temperature
slightly in increments.
 Tap.
 Swipe left or right until is shown in
the middle.
 Tap.
 Swipe left or right until the setting you
want (1: lowest temperature; 9:
highest temperature) is shown in the
middle.
 Tap on the setting you want to con-
firm.
The default setting for the temperat-
ure is5.
Under certain circumstances, a set-
ting from1 to4 can cause negative
temperatures to be reached. This can
cause food to freeze.
Check the temperature setting.
If you change the temperature set-
ting:
 check the temperature display after a
few hours. It will take this long for the
appliance to give an accurate read-
ing.
- Wait for approx.6hours if the refri-
geration appliance is not very full
- Wait for approx.24hours if the refri-
geration appliance is full
If, after this time, the temperature is still
too high or too low:
 Adjust the temperature again.