User manual

Cleaning and care
67
Removing and dismantling the stor-
age drawer (CompactCase)
 Pull the drawer out as far as it will go.
Tilt the drawer slightly upwards and
remove it.
 Use both hands to raise the shelf and
support slightly at the front 1.).
 Pull the shelf slightly forwards 2.) and
remove it either upwards or out at an
angle, making sure that the notches
on the left and right are in line with
the shelf supports.
 Place the shelf and support on a
worktop covered with a soft material
(e.g. a tea towel).
 Pull off the supports from the sides of
the shelf 1.).
 Pull the stainless steel trim forwards
off the shelf 2.).
 Pull off the rear protective strip 3.).
 After cleaning the shelf, reattach the
stainless steel trim, the protective
strip and the supports.
 Insert the shelf together with the sup-
port into the refrigeration appliance
either from above or from the side.
 Slide the shelf backwards as far as it
will go.
 Insert the drawer from above into the
upper or lower guide in the support
as required.