Operating instructions/Installation instructions
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Installation
- Location
- Installation notes
- Building-in dimensions
- Dimensions of the furniture front
- Installing the wine conditioning unit
- Before starting ...
- Tools required
- Weight of the furniture front
- Aligning the building-in niche
- Checking the building-in niche
- Before installation
- Preparing the building-in niche
- Pushing the wine conditioning unit into the building-in niche
- Aligning the wine conditioning unit
- Securing the wine conditioning unit in the building-in niche
- Preparing to install the furniture fronts
- Securing and aligning the furniture front
- Mounting the fixing brackets
- Securing the covers
- Installing the cover in a side-by-side combination
- Fitting the door trim
- Securing the plinth ventilation grille and plinth panel
- Limiting the opening angle of the appliance door
- Electrical connection
- Saving energy
- Guide to the appliance
- Accessories
- Initial commissioning
- Switching on and off
- Selecting additional settings
- The ideal temperature and humidity
- Door alarm
- Storing wine bottles
- SommelierSet
- Automatic defrosting
- Cleaning and care
- Problem solving guide
- Noises
- Service
- EU Conformity declaration
- UK Conformity declaration
- Copyrights and Licences
Problem solving guide
90
Display warnings
Message Cause and remedy
The warning sounds
and the message Close
the door will appear on
the display.
The appliance door is open.
Close the appliance door.
If you wish to turn the alarm off early, touch the OK
sensor on the display.
The alarm will stop.
The temperature display
is dark and the sym-
bol is shown in the dis-
play.
The Sabbath modefunction is switched on. The in-
terior lighting is switched off and the wine condition-
ing unit is cooling down.
You can switch off Sabbath mode at any time (see
“Switching Sabbath modeon or off” in “Selecting
additional settings”).
F Please call Miele Service
appears on the display
and an alarm sounds.
There is a fault.
Make a note of the error message if necessary.
Call the Miele Customer Service Department.
To turn the alarm off, touch the symbol.
The error message will not disappear from the dis-
play until the error has been rectified.
The voltage level is too high/low.
Observe the connection data under “Installation –
Electrical connection”.
Contact the Miele Customer Service Department if
necessary.
To turn the alarm off, touch the symbol.
The error message will not disappear from the dis-
play until the error has been rectified.
The symbol lights up
in the display. The wine
conditioning unit does
not get cold, although
the unit controls are
working.
The Demo modeis switched on. Demo mode allows
the wine conditioning unit to be presented in the
showroom without the cooling system being
switched on. This setting is not needed for domestic
use.
Switch off Demo mode (see “Switching Demo
modeoff” in “Selecting additional settings”).