User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the tumble dryer
- Before using for the first time
- Energy saving tips
- 1. Notes on correct laundry care
- 2. Load the tumble dryer
- 3. Selecting a programme
- 4. Selecting programme settings
- 5. Starting a programme
- 6. End of programme - unload the drum
- Programme chart
- Extras
- Wash2Dry
- Favourite programmes
- Drying assistant
- Timer
- Changing the programme sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Problem solving guide
- Fault messages shown in the display when a programme is cancelled
- Messages in the display
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger
- Cleaning the fluff filter in the condensed water container
- Replacing the condensed water spray jet
- Service
- Installation
- Technical data
- Consumption data
- Settings
Settings
100
Operation/display
Language
The display can be set to appear in
one of several different languages.
The flag after the word Language
(Sprache in German) acts as a guide in
case a language which is not under-
stood has been set.
The language selected is saved.
Code
The code prevents your dryer being
used without your knowledge.
Options
- Activate
If the PIN code has been activated,
you have to enter the PIN code after
switching the dryer on. Otherwise the
dryer cannot be operated.
The factory default PIN code is 250.
- Change
You can enter a PIN code of your
own.
If you forget the PIN code, only Miele
Service can unlock the tumble dryer.
Make a note of your new PIN code.
- Deactivate
For using the dryer without entering
the code. This only appears if the
code had been activated previously.
Clock display
After selecting the clock format you
can set the time of day.
Options
- Clock format
The clock format is set.
– 24 h (factory default)
– 12 h
- Set
The current time is set.
Consumption
You can display the total consump-
tion.
Options
- Previous programme
Energy consumption in the last pro-
gramme run
- Total consumption
Previous total consumption
- Set the cost
Cost, price perkWh