User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the tumble dryer
- Before using for the first time
- Energy saving tips
- 1. Notes on correct laundry care
- 2. Load the tumble dryer
- 3. Selecting a programme
- 4. Selecting programme settings
- 5. Starting a programme
- 6. End of programme - unload the drum
- Programme chart
- Extras
- Wash2Dry
- Favourite programmes
- Drying assistant
- Timer
- Changing the programme sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Problem solving guide
- Fault messages shown in the display when a programme is cancelled
- Messages in the display
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger
- Cleaning the fluff filter in the condensed water container
- Replacing the condensed water spray jet
- Service
- Installation
- Technical data
- Consumption data
- Settings
Settings
102
“Display” off status
To save energy the display and sensor
controls will go out after 10minutes
and the Start/Stop button will flash
slowly. You can change this setting.
Options
- On
The display will go out (after
10minutes):
– if a programme is not selected
after the dryer has been switched
on
– while the programme is running
– after the end of a programme
- On. Not in current prog.
(Factory default)
The display will go out (as described
above) but will remain on while the
programme is running.
You can switch the display back on by
touching any sensor.