User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the tumble dryer
- Before using for the first time
- Energy saving tips
- 1. Notes on correct laundry care
- 2. Load the tumble dryer
- 3. Selecting a programme
- 4. Selecting programme settings
- 5. Starting a programme
- 6. End of programme - unload the drum
- Programme chart
- Extras
- Wash2Dry
- Favourite programmes
- Drying assistant
- Timer
- Changing the programme sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Problem solving guide
- Fault messages shown in the display when a programme is cancelled
- Messages in the display
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger
- Cleaning the fluff filter in the condensed water container
- Replacing the condensed water spray jet
- Service
- Installation
- Technical data
- Consumption data
- Settings
Settings
103
Networking
Miele@home
Control the networking of your tumble
dryer with your home WiFi network.
The following points may appear in the
submenu:
Set up
This message only appears if the
tumble dryer has not yet been connec-
ted to a WiFi network.
Please refer to “Before using for the first
time” for instructions on how to set up
the connection.
Activate
(visible if Miele@home is deactivated)
The WiFi function is reactivated.
Deactivate
(visible if Miele@home is activated)
Miele@home remains set up, the WiFi
function is switched off.
Connection status
(visible if Miele@home is activated)
The following values are displayed:
- The quality of WiFi reception
- The network name
- The IP address
Set up again
(visible if set up)
Resets the WiFi login (network) to im-
mediately re-establish a new connec-
tion.
Reset
(visible if set up)
- The WiFi is switched off.
- The WiFi connection will be reset to
the factory default setting.
The network configuration should be re-
set whenever a tumble dryer is being
disposed of or sold, or if a used tumble
dryer is being put into operation. This is
the only way to ensure that all personal
data has been removed and the previ-
ous owner will no longer be able to ac-
cess the tumble dryer.
A new connection setup has to be car-
ried out in order to use the Miele@home
setting again.