User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the tumble dryer
- Before using for the first time
- Energy saving tips
- 1. Notes on correct laundry care
- 2. Load the tumble dryer
- 3. Selecting a programme
- 4. Selecting programme settings
- 5. Starting a programme
- 6. End of programme - unload the drum
- Programme chart
- Extras
- Wash2Dry
- Favourite programmes
- Drying assistant
- Timer
- Changing the programme sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Problem solving guide
- Fault messages shown in the display when a programme is cancelled
- Messages in the display
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger
- Cleaning the fluff filter in the condensed water container
- Replacing the condensed water spray jet
- Service
- Installation
- Technical data
- Consumption data
- Settings
Settings
104
SmartGrid
The SmartGrid setting is only visible if
the Miele@home setting is set up and
activated.
This function can be used for starting
your tumble dryer automatically at a
time when your energy costs are most
economical.
Activating SmartGrid gives the Delay
start button a new function. Use the
“Delay start” control to set the
SmartGrid. The tumble dryer will then
start within the timeframe specified
when it receives a signal from the en-
ergy supplier.
If it has not received a signal from the
energy supplier by the latest start time
set, the tumble dryer will start automat-
ically (see “Delay start”).
SmartGrid is deactivated as standard.
Remote control
The Remote control setting is only vis-
ible if the Miele@home setting is set up
and activated.
Once the Miele@mobile app has been
installed on your mobile device, you
can check the status of your tumble
dryer from anywhere and start it re-
motely. You can also control it re-
motely via the MobileStart pro-
gramme.
You can switch off the Remote control
setting if you do not want to operate the
tumble dryer with your mobile device.
If Remote control is not switched on, the
app can cause the programme to be
cancelled.
Use the “Delay start” button to set a
time at which you wish to start the
tumble dryer and start the delay start
(see “Delay start/SmartStart”).
The tumble dryer will then start within
the timeframe specified when it receives
your signal.
If it has not received a start signal by
the latest start time set, the tumble
dryer will start automatically.
Remote control is activated by default.