User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the tumble dryer
- Before using for the first time
- Energy saving tips
- 1. Notes on correct laundry care
- 2. Load the tumble dryer
- 3. Selecting a programme
- 4. Selecting programme settings
- 5. Starting a programme
- 6. End of programme - unload the drum
- Programme chart
- Extras
- Wash2Dry
- Favourite programmes
- Drying assistant
- Timer
- Changing the programme sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Problem solving guide
- Fault messages shown in the display when a programme is cancelled
- Messages in the display
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger
- Cleaning the fluff filter in the condensed water container
- Replacing the condensed water spray jet
- Service
- Installation
- Technical data
- Consumption data
- Settings
Settings
106
Programme sequence
Anti-crease
The Anti-crease function reduces
creasing after the end of the pro-
gramme.
The drum will continue to rotate for up
to 2hours after the drying cycle has fin-
ished. This helps to reduce creasing.
Options
- Off
- 1 h
- 2 h (factory default)
Cooling down temp.
The laundry will be cooled down auto-
matically before the end of the pro-
gramme. The automatic cooling-down
phase which takes place before the
end of a programme can be set at a
cooler level for all the drying level pro-
grammes. This means that the cooling
phase is extended.
Selection
The value is set in increments of 1°C.
- 55°C (factory default setting)
- ...
- 40°C
Drying levels
You can alter the drying levels for the
Cottons, Minimum iron and Automatic
programmes.
It can be set to one of 7 different set-
tings.
Factory default: a medium setting