User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the tumble dryer
- Before using for the first time
- Energy saving tips
- 1. Notes on correct laundry care
- 2. Load the tumble dryer
- 3. Selecting a programme
- 4. Selecting programme settings
- 5. Starting a programme
- 6. End of programme - unload the drum
- Programme chart
- Extras
- Wash2Dry
- Favourite programmes
- Drying assistant
- Timer
- Changing the programme sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Problem solving guide
- Fault messages shown in the display when a programme is cancelled
- Messages in the display
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger
- Cleaning the fluff filter in the condensed water container
- Replacing the condensed water spray jet
- Service
- Installation
- Technical data
- Consumption data
- Settings
Settings
107
Machine parameters
Airways indicator
Fluff should be removed after drying.
In addition, this indicator will remind
you to clean the filters when a certain
amount of fluff has collected in them:
Clean the fluff and plinth filters. See the
operating instruction manual for more in-
formation.
You can decide at what level of fluff
this reminder should be given.
Options
You will have an idea of which option
you should pick after a few drying pro-
grammes.
- Off
This reminder does not appear. How-
ever, if there is a very severe block-
age in the ducting, the programme
will be cancelled and the fault mes-
sage
Clean the fluff filter. Check the air-
ways. will appear in the display re-
gardless of this option.
- Heavy
The reminder only appears when
there is a heavy build-up of fluff.
- Normal (factory default)
- Light
The reminder appears when there is
only a small build-up of fluff.
Conductivity
This setting is only relevant for regions
with very soft water.
Very soft water can result in unsatis-
factory drying results.
You should only select this setting if
the water used for washing the laun-
dry is extremely soft with a conduct-
ivity reading (electrical conductivity)
less than 150μS/cm. Contact your
local water authority for the conduct-
ivity level of your mains water supply.
Options
- Normal (factory default)
- Low <150mS (only for regions with
very soft water)