User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the tumble dryer
- Before using for the first time
- Energy saving tips
- 1. Notes on correct laundry care
- 2. Load the tumble dryer
- 3. Selecting a programme
- 4. Selecting programme settings
- 5. Starting a programme
- 6. End of programme - unload the drum
- Programme chart
- Extras
- Wash2Dry
- Favourite programmes
- Drying assistant
- Timer
- Changing the programme sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Problem solving guide
- Fault messages shown in the display when a programme is cancelled
- Messages in the display
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger
- Cleaning the fluff filter in the condensed water container
- Replacing the condensed water spray jet
- Service
- Installation
- Technical data
- Consumption data
- Settings
Warning and Safety instructions
11
Faulty components must only be replaced by genuine Miele ori-
ginal spare parts. The manufacturer can only guarantee the safety of
the appliance when Miele replacement parts are used.
Unauthorised repairs could result in unforeseen dangers for the
user, for which Miele cannot accept liability. Repairs should only be
undertaken by a Miele approved service technician, otherwise any
subsequent damage will not be covered by the warranty.
The accessibility of the plug must always be ensured, in order to
disconnect the tumble dryer from the mains.
If the electrical connection cable is faulty it must only be replaced
by a Miele authorised service technician to protect the user from
danger.
The tumble dryer must be isolated from the electricity supply in
the event of a fault and during cleaning and maintenance.