User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the tumble dryer
- Before using for the first time
- Energy saving tips
- 1. Notes on correct laundry care
- 2. Load the tumble dryer
- 3. Selecting a programme
- 4. Selecting programme settings
- 5. Starting a programme
- 6. End of programme - unload the drum
- Programme chart
- Extras
- Wash2Dry
- Favourite programmes
- Drying assistant
- Timer
- Changing the programme sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Problem solving guide
- Fault messages shown in the display when a programme is cancelled
- Messages in the display
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger
- Cleaning the fluff filter in the condensed water container
- Replacing the condensed water spray jet
- Service
- Installation
- Technical data
- Consumption data
- Settings
Operating the tumble dryer
20
Control panel
a
sensor control
Takes you back one level in the menu.
b
Touch display
c
Start/Stop sensor
Touching the Start/Stop sensor starts the selected programme or cancels a
programme that has already been started. The sensor flashes slowly as soon as
it is possible for a programme to be started and then lights up constantly after
the programme has started.
d
Optical interface
This is used by the Service department as a transmission point.
e
button
For switching the tumble dryer on and off. The tumble dryer switches off auto-
matically to save energy. This occurs 15minutes after the end of the pro-
gramme/anti-crease phase, or after being switched on if no further selection is
made.
Touch display and sensors
The and Start/Stop sensors and the sensors in the display react to finger tip
contact.
The touch display can be scratched by pointed or sharp objects, e.g. pens.
Only touch the display with your fingers.