User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the tumble dryer
- Before using for the first time
- Energy saving tips
- 1. Notes on correct laundry care
- 2. Load the tumble dryer
- 3. Selecting a programme
- 4. Selecting programme settings
- 5. Starting a programme
- 6. End of programme - unload the drum
- Programme chart
- Extras
- Wash2Dry
- Favourite programmes
- Drying assistant
- Timer
- Changing the programme sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Problem solving guide
- Fault messages shown in the display when a programme is cancelled
- Messages in the display
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger
- Cleaning the fluff filter in the condensed water container
- Replacing the condensed water spray jet
- Service
- Installation
- Technical data
- Consumption data
- Settings
Before using for the first time
27
Setting up Miele@home
Skip
Continue
Set up “Miele@home”?
To set up Miele@home now: touch
the Continue sensor control.
Tip: To postpone setup until later: touch
the Skip sensor control. The following
message will then appear in the display:
It is possible to set up later in “Settings” /
“Miele@home”.
Confirm with the OK sensor control.
Via WPS Via App
Which connection method do you
want to use?
Select the connection method you
wish to use.
You will then be guided by the display
and the Miele app.
You will require a WPS-compatible
router for the Via WPSconnection type.
Activate the WPS function on your
router within 2minutes.
Setting the clock format
The time of day can be displayed as a
24 hour or 12 hour clock.
Select the clock format you want and
confirm this with the OK sensor.
The display will change to the next set-
ting.
Setting the time of day
This message only appears if the
tumble dryer has not yet been con-
nected to a WiFi network.
The time of day is set automatically if
connection is established with a WiFi
network.
OK
12 00
11 59
10 58
13 01
14 02
Clock display
Place your finger on the number that
you want to change and move your
finger in the direction you want.
Confirm with the OK sensor.
The display shows further information.