User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the tumble dryer
- Before using for the first time
- Energy saving tips
- 1. Notes on correct laundry care
- 2. Load the tumble dryer
- 3. Selecting a programme
- 4. Selecting programme settings
- 5. Starting a programme
- 6. End of programme - unload the drum
- Programme chart
- Extras
- Wash2Dry
- Favourite programmes
- Drying assistant
- Timer
- Changing the programme sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Problem solving guide
- Fault messages shown in the display when a programme is cancelled
- Messages in the display
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger
- Cleaning the fluff filter in the condensed water container
- Replacing the condensed water spray jet
- Service
- Installation
- Technical data
- Consumption data
- Settings
Wash2Dry
49
Once the programme has come to a
proper end, the Miele washing ma-
chine transfers the programme data
via the router to which the networked
tumble dryer is also connected, as
well as transferring it to the Miele
Cloud.
The tumble dryer automatically sets a
drying programme tailored to the laun-
dry based on the transferred pro-
gramme data.
All you need to do is start the drying
programme once you have loaded the
tumble dryer. No further programme
settings are required on the tumble
dryer.
Tip: The drying programme must be
started within 24 hours of the end of the
wash programme. The data will be kept
available for the tumble dryer during
this period, but will be overwritten when
a new wash programme ends.
Tip: Do not disconnect the tumble dryer
from the network. The programme data
transferred by the washing machine will
be received by the tumble dryer as
soon as you select Wash2Dry.
If you have disconnected the appliance
from the network beforehand, this will
cause a delay in receiving the data.
Requirements for use
In order to use the Wash2Dry function,
the Miele washing machine and
tumble dryer must be networked using
Miele@home services.
Tip: Set up Miele@home as described
in “Before using for the first time”.
Selecting the
Wash2Dry function
Please wait lights up in the display of
the tumble dryer while the wash pro-
gramme is running.
Once the washing machine programme
has come to a proper end, the drying
programme tailored to the laundry will
be displayed.
Once the wash cycle has ended,
place the clean laundry in the tumble
dryer.
To start the programme, all you need
to do is press the Start/Stopsensor
control on the tumble dryer.
The programme will not start on this
tumble dryer after washing delicate
textiles (e.g. curtains) in special wash
programmes.