User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the tumble dryer
- Before using for the first time
- Energy saving tips
- 1. Notes on correct laundry care
- 2. Load the tumble dryer
- 3. Selecting a programme
- 4. Selecting programme settings
- 5. Starting a programme
- 6. End of programme - unload the drum
- Programme chart
- Extras
- Wash2Dry
- Favourite programmes
- Drying assistant
- Timer
- Changing the programme sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Problem solving guide
- Fault messages shown in the display when a programme is cancelled
- Messages in the display
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger
- Cleaning the fluff filter in the condensed water container
- Replacing the condensed water spray jet
- Service
- Installation
- Technical data
- Consumption data
- Settings
Timer
52
The timer can be used to set the time
you wish a programme to finish or start
at. The programme start can be delayed
by up to 24 hours.
Setting the timer
Touch the Timer sensor.
Select the Finish at or Start at option.
Set the hours and the minutes with
the OK sensor.
Changing the timer
The selected timer can be changed be-
fore the programme starts.
Touch the or sensor.
Change the specified time and con-
firm with the OK sensor.
Deleting the timer
The selected timer can be deleted be-
fore the programme starts.
Touch the or sensor control.
The selected delay start period will ap-
pear in the display.
Touch the Delete sensor control.
Confirm with the OKsensor control.
The selected delay start period is de-
leted.
Starting the timer
Touch the Start/Stop sensor.
The time until the programme starts will
appear in the display.
After the programme has started, the
selected delay start time can only be
changed or cancelled by interrupting
the programme.
The programme can now be started.
Touch the Start immediately sensor.
Adding laundry during ongoing delay
start period
Follow the description in “Changing
the programme sequence – Adding or
removing laundry”.
With a longer delay start time, the drum
will rotate occasionally to untangle the
laundry. This is not a fault.