User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the tumble dryer
- Before using for the first time
- Energy saving tips
- 1. Notes on correct laundry care
- 2. Load the tumble dryer
- 3. Selecting a programme
- 4. Selecting programme settings
- 5. Starting a programme
- 6. End of programme - unload the drum
- Programme chart
- Extras
- Wash2Dry
- Favourite programmes
- Drying assistant
- Timer
- Changing the programme sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Problem solving guide
- Fault messages shown in the display when a programme is cancelled
- Messages in the display
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger
- Cleaning the fluff filter in the condensed water container
- Replacing the condensed water spray jet
- Service
- Installation
- Technical data
- Consumption data
- Settings
Changing the programme sequence
54
Changing a programme once it
has started
You cannot change to another pro-
gramme once a programme has started
(this prevents unintentional alterations).
You will need to cancel the current pro-
gramme before you can select a new
one.
Cancelling a programme
Touch the Start/Stop sensor.
The following will appear in the display:
Cancel the programme?
Select Yes.
The following appears in the display:
Programme cancelled.
Open the door.
Selecting another programme
Close the door.
Select the programme you want.
Touch the Start/Stop sensor.
Adding or removing laundry
You have forgotten something but the
programme is already running.
Touch the Add laundrysensor control.
Add laundry and The door can be opened.
appears in the display. The Start/Stop
sensor control flashes slowly.
Open the door.
Add or remove laundry items.
Close the door.
Touch the Start/Stopsensor control.
The programme continues.
Exceptions when adding laundry
In some cases, for example, during
the cooling phase or the Proofing pro-
gramme, it is not possible to add laun-
dry items.
In exceptional cases, the door can be
opened while the programme is run-
ning.