User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the tumble dryer
- Before using for the first time
- Energy saving tips
- 1. Notes on correct laundry care
- 2. Load the tumble dryer
- 3. Selecting a programme
- 4. Selecting programme settings
- 5. Starting a programme
- 6. End of programme - unload the drum
- Programme chart
- Extras
- Wash2Dry
- Favourite programmes
- Drying assistant
- Timer
- Changing the programme sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Problem solving guide
- Fault messages shown in the display when a programme is cancelled
- Messages in the display
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger
- Cleaning the fluff filter in the condensed water container
- Replacing the condensed water spray jet
- Service
- Installation
- Technical data
- Consumption data
- Settings
Cleaning and care
63
Use a vacuum cleaner with a long
crevice nozzle attached to remove
any visible fluff from the upper air
flow openings.
Finally, clean the fluff filters with water.
Cleaning the fluff filters with water
Wipe the smooth plastic surfaces of
the fluff filters with a damp cloth to
clean them.
Flush the filters through under warm
running water.
Shake the fluff filters thoroughly and
then dry them carefully.
Ensure the filters are dry before re-
placing them. Wet filters could cause
operational faults.
Push the lower fluff filter in com-
pletely and lock it with the yellow dial.
Push the upper fluff filter in com-
pletely.
Close the door.