User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the tumble dryer
- Before using for the first time
- Energy saving tips
- 1. Notes on correct laundry care
- 2. Load the tumble dryer
- 3. Selecting a programme
- 4. Selecting programme settings
- 5. Starting a programme
- 6. End of programme - unload the drum
- Programme chart
- Extras
- Wash2Dry
- Favourite programmes
- Drying assistant
- Timer
- Changing the programme sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Problem solving guide
- Fault messages shown in the display when a programme is cancelled
- Messages in the display
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger
- Cleaning the fluff filter in the condensed water container
- Replacing the condensed water spray jet
- Service
- Installation
- Technical data
- Consumption data
- Settings
Cleaning and care
64
Cleaning the plinth filter
Clean the plinth filter when the pro-
gramme running time is longer than
usual or if the following message lights
up in the display: Clean the fluff and
plinth filters. See the operating instruction
manual for more information.
To clear the message, confirm with
OK.
Removing the plinth filter
Press the round, indented area on the
heat exchanger access panel to open
it.
The panel will spring open.
Pull the plinth filter out by the handle.
The right-hand guide pin comes out
when the plinth filter is removed. The
guide pin prevents the access panel
from closing without the plinth filter.
Cleaning the plinth filter
Pull the handle out of the plinth filter.
Clean the plinth filter thoroughly un-
der running water.
Squeeze the plinth filter very carefully
several times as you rinse it.
Rinse the plinth filter until all visible
residues have been removed.
Use a damp cloth to remove any fluff
from the handle.