User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the tumble dryer
- Before using for the first time
- Energy saving tips
- 1. Notes on correct laundry care
- 2. Load the tumble dryer
- 3. Selecting a programme
- 4. Selecting programme settings
- 5. Starting a programme
- 6. End of programme - unload the drum
- Programme chart
- Extras
- Wash2Dry
- Favourite programmes
- Drying assistant
- Timer
- Changing the programme sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Problem solving guide
- Fault messages shown in the display when a programme is cancelled
- Messages in the display
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger
- Cleaning the fluff filter in the condensed water container
- Replacing the condensed water spray jet
- Service
- Installation
- Technical data
- Consumption data
- Settings
Problem solving guide
69
Messages in the display
Message Cause and remedy
000 Access via a code has been activated.
Enter the code and confirm the entry. Deactivate
the code if you do not wish this message to ap-
pear in the display the next time the appliance is
switched on.
Finish/Cooling down The laundry will be cooled down at the end of the
programme.
Either remove the laundry and spread it out to cool
down or leave it in the tumble dryer to cool down
during the cooling phase.
Clean the fluff and
plinth filters. See the
operating instruction
manual for more in-
formation.
The tumble dryer is not working correctly or econom-
ically. Possible causes could be clogging caused by
fluff or detergent residue.
To deactivate the message, confirm with OK.
Please see “Cleaning and care” for notes on clean-
ing.
Clean the fluff filters.
Also check the plinth filter and clean it if neces-
sary.
You can influence when the Clean the fluff and plinth fil-
ters. See the operating instruction manual for more inform-
ation. message lights up.
To do this, follow the instructions in “Airways indic-
ator – Settings”.
Fill the condensate
container with water
The condensed water container is empty. When cer-
tain programmes are being used, water is taken from
the condensed water container and recycled.
To deactivate the message, confirm with OK.
Fill the condensed water container to at least the
―min―mark.
Please open and
close the door
This is to remind you to load the laundry when the
Steam care programme is selected.
Load the laundry in the drum.