User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the tumble dryer
- Before using for the first time
- Energy saving tips
- 1. Notes on correct laundry care
- 2. Load the tumble dryer
- 3. Selecting a programme
- 4. Selecting programme settings
- 5. Starting a programme
- 6. End of programme - unload the drum
- Programme chart
- Extras
- Wash2Dry
- Favourite programmes
- Drying assistant
- Timer
- Changing the programme sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Problem solving guide
- Fault messages shown in the display when a programme is cancelled
- Messages in the display
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger
- Cleaning the fluff filter in the condensed water container
- Replacing the condensed water spray jet
- Service
- Installation
- Technical data
- Consumption data
- Settings
Problem solving guide
72
General problems with the tumble dryer
Problem Cause and remedy
You can hear buzzing or
humming operating
noises.
The compressor (heat pump) is operating. Or you
have selected a programme which sprays con-
densed water into the drum.
No action required. These noises are quite nor-
mal and can be heard when the compressor or
the condensed water pump is operating.
There is no fault.
A programme does not
start
No obvious cause.
Connect the tumble dryer to the mains
Turn on the tumble dryer
Close the door
Check whether the mains fuse has tripped
Has there been a power cut? When power is re-
stored any previously running programme will re-
start automatically.
When the DryFresh,
PowerFresh or Dry-
Care40 extra options
are selected, the drying
level “jumps back” to a
different one.
The drying level you selected previously cannot be
combined with the extra option. The closest pos-
sible drying level is selected automatically.
The display is dark and
the Start/Stop control is
flashing slowly.
The display has switched off automatically to save
energy (Standby mode).
The drum will turn at intervals in the anti-crease
phase.
Press any control. This switches Standby off.
The dryer is switched
off at the end of the
programme.
The tumble dryer switches off automatically. This is
not a fault, but a normal function.
The display is in a dif-
ferent language.
A different language has been selected in “Settings,
Language ”.
Set the language you want. The flag symbol serves
as a guide.