User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the tumble dryer
- Before using for the first time
- Energy saving tips
- 1. Notes on correct laundry care
- 2. Load the tumble dryer
- 3. Selecting a programme
- 4. Selecting programme settings
- 5. Starting a programme
- 6. End of programme - unload the drum
- Programme chart
- Extras
- Wash2Dry
- Favourite programmes
- Drying assistant
- Timer
- Changing the programme sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Problem solving guide
- Fault messages shown in the display when a programme is cancelled
- Messages in the display
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger
- Cleaning the fluff filter in the condensed water container
- Replacing the condensed water spray jet
- Service
- Installation
- Technical data
- Consumption data
- Settings
Problem solving guide
78
Remove the spray jet (optional ac-
cessory). Replace the spray jet.
You can only replace the spray jet us-
ing a special tool. The special tool is
supplied with the new spray jet.
Using the wrong tool can cause
damage.
Doing so can damage the spray jet
or the tumble dryer.
Only use the tool supplied. Do not
use any other tool.
Open the tumble dryer door.
The spray jet is located in the top left of
the door opening.
Attach the tool to the spray jet.
Turn the tool anti-clockwise to un-
screw the spray jet.
Insert the new spray jet into the tool.
Turn the tool clockwise to screw the
spray jet securely in position.
The tumble dryer must not be oper-
ated without the spray jet fitted.