User's Manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Guide to the appliance
- -
- Installation and connection
- Assembling the vacuum cleaner
- Connecting the Comfort handle
- Connecting the PowerUnit and the suction tube
- Inserting the battery
- Connecting the Electrobrush
- General battery information
- Charging the battery (without wall mounting)
- Charging the battery (with wall mounting)
- Wall mounting
- Attaching the mounting plate
- Attaching the charging cable to the wall bracket
- Connecting the accessories holder (if required)
- Connecting the wall bracket
- Battery charging state indicator (while charging)
- Battery charging state indicator (while in use)
- Using the accessories supplied
- Use
- Maintenance
- Problem solving guide
- Error messages
- Cleaning and care
- Service
- Optional accessories
- Electrical connection
- Installation and connection
20
Attaching the mounting plate
2plugs and 2T20 TORX screws are
supplied for attaching the mounting
plate to the wall.
You will also need a battery-operated
screwdriver or a drill (with a drilling dia-
meter of 6mm).
Depending on how your vacuum
cleaner is configured, select a distance
of 45cm or 98cm between the bottom
edge of the mounting plate and the
floor.
Be careful not to damage any cables
laid in the wall.
Attach the mounting plate to the wall.
Attaching the charging cable to the
wall bracket
A cable compartment is located on the
underside of the wall bracket.
Press both release catches on the un-
derside of the wall bracket and re-
move the cable compartment cover.
Insert the supplied charging cable
into the opening from above.
Lay the charging cable in its guide.