User's Manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Caring for the environment
- Guide to the appliance
- -
- Installation and connection
- Assembling the vacuum cleaner
- Connecting the Comfort handle
- Connecting the PowerUnit and the suction tube
- Inserting the battery
- Connecting the Electrobrush
- General battery information
- Charging the battery (without wall mounting)
- Charging the battery (with wall mounting)
- Wall mounting
- Attaching the mounting plate
- Attaching the charging cable to the wall bracket
- Connecting the accessories holder (if required)
- Connecting the wall bracket
- Battery charging state indicator (while charging)
- Battery charging state indicator (while in use)
- Using the accessories supplied
- Use
- Maintenance
- Problem solving guide
- Error messages
- Cleaning and care
- Service
- Optional accessories
- Electrical connection
- Installation and connection
21
Refit the cover and close the cable
compartment.
Then turn over the wall bracket.
Connecting the accessories holder
(if required)
An accessories holder is supplied for
storing the three-piece accessory set
(see “Using the accessories supplied”).
Push the accessories holder on to the
wall bracket as far as it will go.
Connecting the wall bracket
Slide the wall bracket down into the
mounting plate from above until it
audibly clicks into place.
Slide the PowerUnit of the fully as-
sembled vacuum cleaner, with the
battery inserted, down into the wall
bracket from above.
Plug the charger into the power
socket.
The charging process will start.