PerfectCool Freezer FNS 37492 iE 8mieleusa.
PerfectCool Freezer FNS 37492 iE SPECIFICATIONS FNS 37492 iE — Item 37374921USA - Left Hinged (convertible) Overall Unit Width 22” (559 mm) Overall Unit Height 6911/16” (1770 mm) Overall Unit Depth 211/2” (545 mm) Niche Minimum Cabinet Opening Width 221/16 ” (560 mm) Minimum Cabinet Opening Height 693/4” (1772 mm) Minimum Cabinet Opening Depth 215/8” (550 mm) Interior Volume Freezer Volume 7.
PerfectCool Freezer FNS 37492 iE INSTALLATION DIMENSIONS For additional information on Plumbing, please refer to the Plumbing section in the Install Manual.
PerfectCool Freezer FNS 37492 iE VENTILATION DIMENSIONS - Air intake (1) occurs via the plinth at the bottom of the appliance and the air escapes at the top (2) at the rear of the housing unit. - A ventilation gap of at least 1 5/8” (40 mm) depth must be provided behind the appliance for air to circulate. - The ventilation cross-sections in the plinth housing unit and above the appliance must amount to at least 78 3/4”2 to ensure that air can circulate without obstruction.
PerfectCool Freezer FNS 37492 iE TOP VENTILATION CROSS-SECTION (1) Directly above the appliance with a ventilation grill (free airflow of at least 78 3/4”2). (2) In between the housing unit and ceiling. (3) Through a suspended ceiling. - Please refer to manual for further ventilation details.
PerfectCool Freezer FNS 37492 iE BOTTOM VENTILATION SLITS DIMENSIONS If you would like to use the ventilation slits: - Cut an opening in the plinth (2) as shown in the figure. - Place the ventilation grille (1) inot the opening.
PerfectCool Freezer FNS 37492 iE CUSTOM PANEL j - Custom door panel k - Unit's door FNS 37492 iE Page 7 of 9 Specification Sheets TRS 05232017
PerfectCool Freezer FNS 37492 iE CUSTOM PANEL CONTINUED SPECIFICATIONS Custom Panel Refer to manual for further detail Maximum Panel Weight 50.
PerfectCool Freezer FNS 37492 iE ADJUSTABLE DOOR HINGE 90o or 120o Opening The door hinges are factory set so that the door can be opned wide. However if the opening angle of the door needs to be limited for any reason, the hinge can be adjusted to accommadate this. Insert the limit pins provided into the hinges from above. This will limit the opening angle of the applinace door to 90 o.
