Operating and Installation manual

Preparation for air extraction
mode
^ If using a 6" (150 mm) diameter
exhaust hose, attach the supplied
vent collar to the exhaust hose with a
hose clamp.
^ If using a 5" (125 mm) diameter
exhaust hose, place the supplied
reducing collar into the vent collar
and attach the exhaust hose to the
reducing collar with a hose clamp.
(see "Air extraction").
^
Place the exhaust hose onto the vent
collar of the hood.
^
See "Air extraction" for further
information on installing the exhaust
hose.
^
DA 2210: The hood has two vent
collars for two 6" (150 mm) diameter
exhaust hoses. The supplied Y-
adapter can be used to feed the
exhaust from both connections into
an 8" (200 mm) diameter common
duct.
Installation
29
dai2717
dai2699