KS37472iD Product Manual

Before installation
^
Before installation, remove the
accessories bag containing
installation components and
accessories from the appliance, and
remove the sealing strip from the
appliance door.
^
Do not remove the following from the
back of the appliance:
– The spacers (depending on model).
These ensure the gap required
between the back of the appliance
and the wall is maintained.
– Depending on model, the pouches
located in the metal grille (heat
exchanger).
They are required for the correct
functioning of the appliance. The
contents are not poisonous or
dangerous.
^
Remove any cable clips from the
back of the appliance.
^
Check that all parts at the back of the
appliance are unhindered. Carefully
remove any hindrance.
^
Remove the red transport safety
device a and close the created hole
with the included stopper b.
Wall spacer on the rear side
At a furniture depth below 21 3/4''
(553 mm), you can remove the wall
spacer from the rear side of the
appliance so that you can push the
appliance completely into the nice.
The removal of the wall spacer can lead
to a higher energy consumption since
the ventilation cross-section is reduced.
^
Loosen the screw and remove the
wall spacer.
Installation information
64