Assembly instruction
Umbau- und Montageanweisung
10 von 25 M.-Nr. 11313351
20.01.2020 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
The arrow embossed on the top of the plinth points to the front, see Fig.1.
A Level the plinth on the floor.
A Mark the hole positions.
A Drill holes measuring 12mm in diameter in the marked positions, to a depth of approximately 65mm.
A Insert plugs (5) into the holes, see Fig.2.
A Line the plinth up with the underlay supplied (4), see Fig.2.
A Fasten the plinth to the floor with the hexagonal-head wood screws (1), 8.4 washers (2) and 15x44x3 washers (3),
see Fig.2.
Fitting a washing machine to the plinth
A Fit the tensioning strips on the plinth and fasten them in the appropriate holes (1), see Fig.3.
A Secure each tensioning strip to the plinth with 1 M6x30 bolt (1), 2 galvanised B6.4 washers (2) and 1 M6 nut (3). Do
not tighten the nuts yet, see Fig.4.
A Unscrew the washing machine feet by at least 5mm.
A Set the washing machine down on the plinth and slide it into the clamping plates with the rear feet.
A Level the washing machine on the plinth.
A Use the tensioning strips to fix the washing machine to the front feet, see Fig.4.
A Fit another M6 nut (4) to each of the feet to counter the first nut, see Fig.4.
A Screw 1 M6x20 screw (1) into each of the clamping plates and tighten, see Fig.5.
Fitting a tumble dryer to the plinth
A Unscrew the tumble dryer feet by at least 5mm.
A Set the tumble dryer down on the plinth and slide it into the clamping plates with the rear feet.
A Level the tumble dryer on the plinth.
A Screw one M6x20 screw (1) into each of the clamping plates and tighten, see Fig.6.
Fitting the plinth panels
A Use four M4x25 screws to attach each of the two side panels, see Fig.7.
A Use four M4x25 screws to attach the front panel, see Fig.7.
en
en-US
APCL 15/30 stand installation instructions
Reason: Installing a washer or dryer on a stand enables a more ergonomic height to be achieved.
Parts included
Quantity Mat. no. Designation
1 Stand
2 Clamp
4 B6.4 washer
2 M6 x 30 bolt
4 M6 nut
4 S12 plug