Instructions for use

en - English
35
 Risk of electric shock caused by
the XCIbox falling down off the wall
and into water.
If it is not secured properly and cor-
rectly, the XCIbox can fall down off
the wall, causing an electric shock.
If an XCIbox falls down off the wall,
it must be taken out of service imme-
diately. Replace the XCIbox with a
new one or have it checked by the
Miele Customer Service Department.
Carrying out the installation
Service and repair work must only be
carried out by a suitably qualified elec-
trician in accordance with all appropri-
ate local and national safety regula-
tions.
 Disconnect the Miele Professional
machine from the mains voltage.
 Attach the XCIbox to the wall using
the 4screws (4x40) and plugs (S6)
provided. See Fig. in the
“”chapter.
 Alternatively, the XCI box can be at-
tached to the wall using the adhesive
strips provided. See Fig. in the
“”chapter.
 Establish the connection between the
XCIbox and the Miele Professional
machine and the external hardware
(e.g.payment system).
When connecting external hardware
provided by other manufacturers, the
cable cross-section must not be less
than 1.0mm
2
with a maximum cable
length of 2.50m (98 ¹/₃").
Mounting the cable strain relief
The connection cables of external hard-
ware must be fastened to the XCIbox
using cable glands and cable strain re-
lief fixtures. See Fig. in the
“”chapter at the end of these operat-
ing and installation instructions.
 Remove the lid from the XCIbox (re-
move the 2screws).
 Remove one or more of the cable
strain relief fixturesa.
 Stand the XCIbox on its narrow end
so that the sealed connection holes
are at the top.
 Using a screwdriver, press out the
round indentation in the connection
hole b.
Tip: Pierce through the groove round
the edge at several places using a
screwdriver.
 Insert the counter nutc.
 Screw on the threaded fittingd.
Tip: Slide the screw cape over the
end of the connection cable for the ex-
ternal hardware.
 Guide the connection cable through
the threaded fitting and into the
XCIbox.
 Tighten the screw cap.
The screw cap provides protection
against moisture and dust.
 Secure the connection cable with the
strain relieff.
 Make the required connections for
the external hardware in the XCIbox.
 Close the lid on the XCIbox (screw in
the 2screws).