Fitting Instructions 3

Umbau- und Montageanweisung
M.-Nr. 11313350 7 von 45
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten. 04.09.2019
Included parts
No. Mat. no. Designation
1 Plinth
2 Clamp
4 Washer B6.4
2 Hexagonal bolt M6x30
4 Nut M6
4 Plug S12
4 Washer 8.4
4 Hexagonal-head wood screw 8x65
8 Washer 38x4
20 Underlay
2 Clamping plate
4 Raised-head screw CEM6x12
2 Hexagonal bolt M6x20
1 Front panel (box plinth only)
2 Side panel (box plinth only)
12 Raised-head screw M4x25 (box plinth only)
Danger due to incorrectly carried out service and repair work
WARNING
Danger due to incorrectly carried out service and repair work
There is a risk of serious damage, injury and even death if service and repair work is carried out incorrectly.
A Service and repair work should only be carried out by a suitably qualified electrician with specialist training,
knowledge and experience.
A All appropriate safety regulations must be taken into account.
A First read the Technical Service Documentation (TSD), then commence work.
Measures to be carried out before any service work is commenced
– Carry out appropriate safety tests on the appliance.
– Disconnect all machine utility connections in accordance with the operating instructions.
After service work has been completed, the following measures must be carried out:
– Carry out appropriate safety tests on the appliance.
– Check the appliance for correct operation.
Risk of cuts during service and maintenance work
WARNING
Components may have sharp edges.
There is a risk of cuts during service and maintenance work.
A Protective gloves should be worn.