Operating instructions

Cleaning the casing
,
Disconnect the appliance from
the electricity supply before any
cleaning and maintenance work on
the casing.
Do not use any abrasive cleaning
agents.
Depending on the level of soiling, the
casing can be wiped with a wet or dry
E-cloth (see "Optional accessories").
Automatic rinse
The automatic rinse function clears the
steam generator of mineral deposits
from the evaporated water.
After a water throughput of approx. 3
litres, the water from the steam
generator is drained off into the residual
water container when the Fashion
Master is next switched on.
The rinsing process lasts a couple of
minutes. During the rinsing process the
indicator light on the iron does not light
up and the iron does not heat up when
the steam ironing system has been
switched on.
^
If the k indicator light comes on, fill
the water container.
^
If the 2 indicator light comes on,
empty and replace the residual water
container.
The contents of the steam generator will
drain off into the residual water
container. Some steam will escape
during this process.
The 2 indicator light comes on.
Emptying the residual water
container
The residual water container may be
hot after rinsing.
^ Set the appliance to its highest
working position (see "Adjusting the
height") to allow access for removing
the residual water container.
Only remove the residual water
container when prompted by the 2
indicator light.
^
Remove, empty, clean and dry the
residual water container.
The residual water container can be
cleaned in the dishwasher or by hand,
using hot water with a little washing-up
liquid.
Cleaning and care
39