User manual

Problem solving guide
67
Troubleshooting
Problem Cause and remedy
The steam ironing sys-
tem cannot be switched
on.
The steam ironing system does not have any power.
 Check that
– the plug is inserted into the wall socket and that
the socket is switched on.
– the fuse in your fuse panel has not tripped.
After an interruption to
the power supply, the
steam ironing system
does not work any
more.
The steam ironing system is switched off
 Use the  button on the control panel to switch
the steam ironing system on.
If a power cut occurred during the automatic rinse,
the cycle will be repeated when the steam ironing
system is switched on again.
If the power cut occurred during descaling, the pro-
cess will be resumed from the stage at which it was
interrupted when the appliance is switched on again.
The height of the iron-
ing board cannot be ad-
justed.
The ironing board is not locked into place on both
sides of the tower.
 Use both hands to pull the ironing board up and
into the horizontal position until the locking mech-
anism audibly clicks into place on both sides of
the tower (see “Assembly”).
The steam ironing sys-
tem cannot be dis-
mantled.
The steam ironing system is not in its lowest working
position.
 Adjust the steam ironing system to its lowest
working height (see “Dismantling”).
The residual water drawer is not inserted completely
and is not locked in place.
 Push the residual water drawer back into the tower
until it locks into place.
 Then adjust the steam ironing system to its lowest
working height (see “Dismantling”).