User manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Operating the tumble dryer
- Before using for the first time
- 1. Notes on correct laundry care
- 2. Load the tumble dryer
- 3. Select a programme and start it
- 4. Remove the laundry
- Options
- Delay start
- Programme chart
- Changing the programme sequence
- Cleaning and care
- Fragrance flacon
- Problem solving guide
- After sales service
- Installation and connection
- Consumption data
- Technical data
- Programmable functions
- Programming
- I) To access a programmable function
- II) To select a programmable function
- III) To select a different option
- IV) To exit programming
- Example
- Cottons programme - drier or damper
- Minimum iron programme - drier or damper
- Extended cool down
- Buzzer volume
- Keypad tone
- Code
- Conductivity
- Additional drying levels
- Standby
- Automatic switch-off
- Memory
- Anti-crease
Warning and Safety instructions
10
Heat pump t
echnology and refrigerant:
The heat pump in this tumble dryer uses a refrigerant which is
condensed by the compressor and led in a closed circuit through
the heat exchanger unit where heat exchange with the circulating
drying air takes place.
– The humming noises caused by the heat pump are normal and do
no
t impair the efficient functioning of the dryer.
– The refrigerant is not flammable or explosive.
– In general it is not necessary to leave the dryer standing for any
len
gth of time before it is connected to the mains provided it has
been transported and installed correctly (see "Installation and
connection").
If it has not been transported as described, ensure that the
recommended standing time prior to first operation is observed.
Otherwise the heat pump can be damaged.
– This tumble dryer contains fluorinated greenhouse gases. They
ar
e hermetically sealed.
Designation: R 134a