User manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Operating the tumble dryer
- Before using for the first time
- 1. Notes on correct laundry care
- 2. Load the tumble dryer
- 3. Select a programme and start it
- 4. Remove the laundry
- Options
- Delay start
- Programme chart
- Changing the programme sequence
- Cleaning and care
- Fragrance flacon
- Problem solving guide
- After sales service
- Installation and connection
- Consumption data
- Technical data
- Programmable functions
- Programming
- I) To access a programmable function
- II) To select a programmable function
- III) To select a different option
- IV) To exit programming
- Example
- Cottons programme - drier or damper
- Minimum iron programme - drier or damper
- Extended cool down
- Buzzer volume
- Keypad tone
- Code
- Conductivity
- Additional drying levels
- Standby
- Automatic switch-off
- Memory
- Anti-crease
Installation and connection
55
Additional installation
r
equirements
F
or safety reasons the tumble
dryer must be disconnected from the
electricity supply before installation.
Building under a continuous
workt
op/in a row of kitchen units
It is very important to avoid a
build-up of heat. The warm air which
is expelled from the dryer must be
able to dissipate. Warm air which
cannot dissipate could cause a fault.
– The electrical socket must be located
in an accessible position near the
appliance.
– Drying durations may increase
sli
ghtly.
A build-up of heat can be avoided by:
– Adjusting the screw feet so that there
is a gap of at least 20 mm between
the floo
r and the bottom of the dryer.
– Creating a gap for the dryer in the
kitch
en furniture plinth facing.
– Creating ventilation gaps in the
kitchen unit.
Pushing the dryer under a worktop
This tumble dryer is suitable for
pushing
under a worktop if there is
space to do this without removing the
lid.
– Building-under kit
A b
uilding under kit is required if
the lid of the tumble dryer needs to
be removed in order to build it under
a worktop.
It must be installed/dismantled by a
suitably qualified fitter.
The lid of the tumble dryer is replaced
by the cover plate supplied with the
building under kit. It must be fitted by a
suitably qualified fitter to ensure
electrical safety.
Fitting instructions are supplied with the
building-under kit.
Optional accessories
– Washer-dryer stack
The tumble dryer can be combined with
a Miele washing machine in a washer-
dryer stack. The appropriate Miele
washer-dryer stacking kit is required.
– Plinth
The tumble dryer can be fitted on a
pli
nth with drawer (please note the
plinth may not be available in all
countries).