Operating Instructions Condenser Dryer T 1570 C To prevent accidents and machine damage read these instructions before installation or use. U M.-Nr.
Contents IMPORTANT SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Guide to the dryer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Before loading the dryer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Using the dryer. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 1. Turn on the dryer and load the laundry . . . .
IMPORTANT SAFETY INSTRUCTIONS ,WARNING - To reduce the risk of fire, electric shock, or injury when using your appliance, follow basic precautions, including the following: Read all instructions before using the appliance. Do not dry articles that have been previously cleaned, washed, soaked in, or spotted with gasoline, dry-cleaning solvents, or other flammable or explosive substances. They give off vapors that could ignite or explode. Do not allow children to play on or in the appliance.
IMPORTANT SAFETY INSTRUCTIONS Do not repair or replace any part of the appliance or attempt any servicing unless specifically recommended in these Operating Instructions. Repairs to electrical appliances should only be performed by qualified personnel. Incorrectly repaired machines may pose a considerable risk to the user. GROUNDING INSTRUCTIONS This appliance must be grounded.
Guide to the dryer 1 Supply cable with plug 2 Control panel 3 Drum door 4 Exhaust connection (right, left or rear) 5 Four height-adjustable legs 5
Guide to the dryer Push buttons Indicators – Door Opens the door or can be used to cancel a program (does not stay pushed in). – Empty out container The condensed water container should be emptied. – ON / OFF Turns the machine on and off or cancels a program. When the machine is turned on, the “On” indicator will light up if the door is closed. If the door is open the drum light, located inside the machine, will be on.
Before loading the dryer Drying tips The appliance must be correctly installed and connected before the first use. Please see the "Installation instructions". Knitted fabrics and flannel tend to shrink when washed and dried for the first time. Do not over dry these fabrics. ^ Check the dryer drum for any residue that may have deposited during the manufacturing process. If necessary clean out with a cloth. Permanent press and delicate fabrics tend to crease.
Using the dryer 1. Turn on the dryer and load the laundry ^ Press the "On/Off" button to turn on the dryer. To prevent fabric damage, check that laundry will not be caught in the closed door. ^ Press the "Door" button to open the door. ^ Load the laundry loosely into the drum. ^ Close the door with a firm swing - do not push it shut. Do not use fabric softener sheets in this dryer. Silicates contained in these sheets could cause the dryer to overheat.
Using the dryer 2. Select a program 3. Select the Buzzer to signal the end of the program (if desired) ^ Press the "Buzzer" button. ^ Turn the program selector clockwise or counterclockwise to the desired program. 4. Select a lower temperature (if necessary) Please refer to the "Programs" chart. The program status will be stored for 30 minutes in the event of a power failure. ^ Press the "Low temp." button to reduce the temperature when drying delicate fabrics.
Programs Program COTTONS Extra dry Normal Normal- Hand iron r Hand iron rr Machine iron Fabric For drying laundry that will be stored away, such as linens or seasonal clothing. Uniform loads of cotton e.g. sheets, underwear, socks. Knitted cotton fabrics that may shrink, e.g. jersey material or lightweight cottons. Cotton or linen fabrics to be left damp for easier ironing. Note The "Extra dry" program should not be selected for jersey materials. Items may shrink.
Using the dryer 5. Start the program 6. At the end of a program The "Anti-crease/Finish" indicator will light at the end of a program. ^ Turn the program selector to "Finish". ^ Press the "START" button. ^ Press the "Door" button to open the door. ^ Remove the laundry. ^ Check that the drum is empty. ^ Clean the lint filter before or after each use (see "Cleaning the lint filter".) ^ Press the "On/Off" button to turn off the dryer.
Dryer care Cleaning the lint filter The lint filter must be cleaned before or after every program. Before cleaning the tumble dryer, disconnect the machine from the power supply. Never use abrasive cleaners, scouring pads, steel wool or caustic (oven) cleaners on the dryer. They will damage the surface. Cleaning the exterior and the control panel ^ The exterior and the control panel can be cleaned with warm water and liquid dish soap applied with a soft sponge. ^ Wipe dry using a soft cloth.
Dryer care Emptying the condensed water container To empty the container Depending on your type of installation, the condensed water will either be pumped to a drain, or collected in the condensed water container, located in the upper left corner of the machine. The container holds approximately 1 gallon of water. The container should be emptied weekly.
Dryer care Cleaning the heat exchanger Disconnect the machine from the power supply. ^ The heat exchanger should be cleaned every 6 months. ^ Open the door. ^ Remove the cover. ^ Turn the lever so that it is vertical. ^ Turn both levers, on the heat exchanger, so that they are vertical.
Dryer care ^ Pull out the heat exchanger. – and along the two long sides ^ Clean the heat exchanger: ^ Stand the heat exchanger lengthwise on a towel until it dries. ^ Replace the heat exchanger in the reverse order. ^ Make certain the heat exchanger is pushed in all the way and that the cover is firmly closed. Otherwise water may leak from the machine.
Dryer care Changing the light bulb ,WARNING To reduce the risk of electric shock, disconnect this appliance from the power supply by unplugging or tripping the circuit breaker. Power failure - Emergency door release ^ Pull forward on the unhinged side of the door. ^ Unscrew the plastic bulb cover located inside the drum and above the door (see illustration.) ^ Replace the light bulb with a temperature proof bulb (part # 02 150 900) available from Miele’s Technical Service Department.
Quick Guide Remove this guide for easy reference Please read all instructions, especially the "Important Safety Instructions", before using the dryer.
Quick Guide 1. Turn on the dryer and load the laundry 2. Select a program ^ Press the "On/Off" button to turn on the dryer. ^ Turn the program selector clockwise or counterclockwise to the desired program. 3. Select the Buzzer to signal the end of the program (if desired) ^ Press the "Door" button to open the door. ^ Load the laundry into the drum. Make sure that there is enough space in the drum for clothes to tumble freely.
Quick Guide 4. Select a lower temperature (if necessary) 6. At the end of a program The "Anti-crease / Finish" indicator will light. ^ Turn the program selector to "Finish". ^ Press the "Low temp." button to reduce the temperature when drying delicate fabrics. ^ Press "Door" and remove the laundry. 5. Start the program ^ Press "START". ^ Clean the lint filter. ^ Press the "On/Off" button to turn off the dryer.
Quick Guide Program COTTONS Extra dry Normal Normal- Hand iron r Hand iron rr Machine iron Fabric For drying laundry that will be stored away, such as linens or seasonal clothing. Uniform loads of cotton e.g. sheets, underwear, socks. Knitted cotton fabrics that may shrink, e.g. jersey material or lightweight cottons. Cotton or linen fabrics to be left damp for easier ironing. Note The "Extra dry" program should not be selected for jersey materials. Items may shrink.
Frequently asked questions With the following guide, minor problems can be fixed without a service call. What if Possible fault . . . the tumble Check whether the "On" dryer fails to start indicator lights up. If so, when turned on? failure to start may be due to an incorrect program selection procedure. . . . the laundry is not dry enough? . . . the drying times are too long? Fix Repeat the program selection procedure in the correct sequence, see "Using the dryer".
Frequently asked questions What if, . . . ? Possible fault . . . the "anti-crease" indicator lamp in the sequence indicator display starts flashing? Fix – Turn the program selector to "finish". – Turn the machine off and then on again. – Select a program.. – Press the "Start" button. If the indicator lamp starts flashing again, this indicates a fault in the machine. Please contact the Miele Service Dept. . . . the drum door opens The machine has during the drying cycle? overheated.
Frequently asked questions What to do if, . . . ? Cause . . . Remedy . . . . . . drops of water appear along the upper edge of the drum door? This may not be a problem. A dual filter system with two seals is used to prevent lint from becoming deposited in the heat exchanger. These two seals may occasionally cause condensed water to form on the door. Laundry coming into contact with these drops of water will dry within a few minutes. . . .
After Sales service In the event of a problem which you cannot fix yourself, or to order spare parts please contact: – Your Miele Dealer or – The Miele Technical Service Department USA 1-800-999-1360 techserv@mieleusa.com CDN 1-800-565-6435 service@miele.ca When contacting the Technical Service Department, please quote the model and serial number of your appliance. They can be found on the data plate located below the drum opening.
Installation Instructions To prevent accidents and machine damage read these instructions before installation or use.
IMPORTANT SAFETY INSTRUCTIONS Installation, repair and maintenance work should be performed by a Miele authorized service technician. Work by unqualified persons could be dangerous and could void the warranty. Before installation, disconnect the tumble dryer from the electrical supply by unplugging the power cord or tripping the circuit breaker. GROUNDING INSTRUCTIONS This appliance must be grounded.
INSTALLATION INSTRUCTIONS Disposal of the packing materials The cardboard box and packing materials protect the appliance during shipping. They have been designed to be biodegradable and recyclable. To prevent suffocation ensure that any plastic wrappings, bags etc. are disposed of safely and kept out of the reach of children. Please recycle. Disposal of an old appliance Old appliances may contain materials that can be recycled.
Installation Leveling the dryer Installation site An air flow gap of 3/8 " (10 mm) must be provided between the machine and the floor. This air flow gap must not be blocked by a toekick or thickpiled carpets. It is possible to install this appliance under a continuous countertop. The machine lid can be removed, if necessary. The tumble dryer can also be placed on top of a Miele washing machine for a stacked installation. An appropriate stacking kit is required.
Installation Changing the decor panel Fitting a toekick panel Note: The door should be closed when installing the decor panel. The appliance toekick below the door can be concealed using a toekick panel. ^ On the door lock side remove the 4 screws (3 on the side and 1 underneath) and the door strip. The height and depth of the appliance toekick cannot be altered. ^ Loosen the remaining 7 screws on the lower and side decor strips until the decor panel can be bowed slightly and taken out.
Installation Connecting to an external drain The condensed water can be sent directly to a drain if the machine is installed near a sink or standpipe. The machine is equipped with a nonreturn valve that will prevent water from flowing back into the machine if there is a problem in the drainage system. Max. drain hose length: 10 ft Max. drain height: 4 ft.
Installation ^ Close the water inlet port above the condensed water container with the bottom part of the rubber plug. The plug must face towards the interior of the machine so that the condensed water container can be easily inserted. ^ Attach the elbow to the hose and secure it to the sink or into the drain pipe. If room is available, it can be inserted into the stand pipe used by the washing machine. The water will now be drained automatically and the container will not need to be emptied.
Installation Make the electrical connection GROUNDING INSTRUCTIONS This appliance must be grounded. In the event of malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for electric current. This appliance is equipped with a cord having an equipment grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
29
30
31
All rights reserved / 4503 For the most updated manual check the Miele website. M.-Nr.