User Manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Guide to the appliance
- Controls and display
- Accessories
- Operating principles
- Before using for the first time
- Water hardness
- Filling the water container
- Filling the coffee bean container
- Switching on and off
- Adjusting the central spout to the correct cup height
- Making drinks
- Grinder setting
- Amount of coffee, brew temperature and pre-brewing
- Portion size
- User profiles
- Settings
- Cleaning and care
- Cleaning intervals - Quick guide
- Cleaning by hand or in the dishwasher
- Unsuitable cleaning agents
- Waste container, drip tray and drip tray cover
- Cleaning the water container
- Removing and cleaning the water container filter
- Central spout
- Milk pipework
- Bean container and ground coffee chute
- Cleaning the housing
- Opening the menu
- Rinsing the appliance
- Rinsing the milk pipework
- Cleaning the milk pipework using the maintenance programme
- Degreasing the brew unit and cleaning the interior
- Descaling the appliance
- Transporting the machine
- Problem solving guide
- After sales service and warranty
- Saving energy
- Electrical connection
- Installation
- Appliance dimensions
- Technical data
Problem solving guide
65
Unsatisfactory results
Problem Possible cause and remedy
The coffee is not hot
enough.
The cup has not been pre-heated.
The smaller the cup and the thicker its walls, the
more important it is to pre-heat it.
Pre-heat the cup, for example with hot water.
The brewing temperature has been set too low.
Set a higher brewing temperature.
The filters in the brew unit are blocked.
Remove the brew unit and clean it by hand.
Degrease the brew unit.
The heating-up time is
getting longer, the
amount of water being
dispensed is incorrect
and the coffee machine
is not performing
properly. Coffee drinks
are being dispensed
very slowly from the
central spout.
The coffee machine needs descaling.
Descale the coffee machine.
Coffee is not flowing
out of the central spout.
Or coffee is only being
dispensed via one
spout.
The central spout has a blockage.
Rinse the coffee pipework.
If there is still no coffee coming out, or coffee is
only coming out of one side, clean the dispensing
spouts with the cleaning brush.
The consistency of the
milk froth is
unsatisfactory.
The milk temperature is too high. Good milk froth can
only be achieved with cold milk (below 10°C).
Check the temperature of the milk in the milk flask.
The milk pipework is blocked.
Clean the central spout with integrated
cappuccinatore and the milk pipework with the
cleaning brush supplied.