Installation Instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Machine description
- Controls and indicators
- Accessories
- Operation
- Before first use
- Water hardness
- Filling the water tank
- Filling the coffee bean container
- Switching on and off
- Adjusting the coffee dispensers to the cup height
- Preparing beverages
- Grinder setting
- Amount of coffee, brew temperature, and pre-brewing
- Portion size
- Profiles
- Settings
- Cleaning and care
- Overview of cleaning intervals
- Clean by hand or in dishwasher
- Unsuitable cleaning agents
- Grounds container, drip tray, and drip tray cover
- Cleaning the water container
- Removing and cleaning the water container filter
- Main dispenser
- Milk pipe
- Bean container and ground coffee chute
- Cleaning the casing
- Opening the menu
- Rinsing the machine
- Rinsing the milk pipe
- Cleaning the milk pipe with the maintenance program
- Degreasing the brew unit and cleaning the interior
- Descaling the appliance
- Transport
- Frequently Asked Questions
- Service and warranty
- Saving energy
- Electrical connection
- Installation
- Appliance dimensions
- Technical data
Frequently Asked Questions
59
Unusual performance of the coffee system
Problem Possible cause and solution
The display remains
dark when the coffee
machine is turned on
using theOn/Offbut-
ton.
The On/Off button was not held for long enough.
Tap and hold the On/Offbutton for at least
3seconds.
The electrical plug is not properly plugged into the
socket.
Insert the electrical plug into the socket.
The breaker has tripped because the coffee machine,
voltage, or another appliance is defective.
Unplug the coffee machine.
Contact a qualified electrician or Miele Service.
The coffee machine
turns off suddenly.
The factory-set switch-off time (20minutes) or the
switch-off time you have programmed has been
reached.
If required, you can select a new switch-off time
(see “Settings – Timer”).
The plug is not properly plugged into the electrical
socket.
Insert the plug into the electrical socket.
The sensor buttons do
not respond.
The machine can no
longer be operated.
There is an internal fault.
Disconnect power by unplugging the power cord
from the electrical outlet and or switching off the
circuit breaker.
The display is hard to
see or not legible.
The display brightness has been set too low.
Change this setting (see “Settings”).