Installation Instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Machine description
- Controls and indicators
- Accessories
- Operation
- Before first use
- Water hardness
- Filling the water tank
- Filling the coffee bean container
- Switching on and off
- Adjusting the coffee dispensers to the cup height
- Preparing beverages
- Grinder setting
- Amount of coffee, brew temperature, and pre-brewing
- Portion size
- Profiles
- Settings
- Cleaning and care
- Overview of cleaning intervals
- Clean by hand or in dishwasher
- Unsuitable cleaning agents
- Grounds container, drip tray, and drip tray cover
- Cleaning the water container
- Removing and cleaning the water container filter
- Main dispenser
- Milk pipe
- Bean container and ground coffee chute
- Cleaning the casing
- Opening the menu
- Rinsing the machine
- Rinsing the milk pipe
- Cleaning the milk pipe with the maintenance program
- Degreasing the brew unit and cleaning the interior
- Descaling the appliance
- Transport
- Frequently Asked Questions
- Service and warranty
- Saving energy
- Electrical connection
- Installation
- Appliance dimensions
- Technical data
Frequently Asked Questions
63
Problem Possible cause and solution
The descaling process
was started inadver-
tently.
The descaling program cannot be stopped once OK
has been tapped.
It must now be completed through to the end. This is
a security setting to fully descale the coffee machine.
It ensure a long service life and that your coffee
machine is functioning correctly.
Descale the coffee machine (see “Descaling the
machine”).
The milk sputters when
it is dispensed. Hissing
noises can be heard
when milk is being
heated up or frothed.
Although the milk
should be frothed, only
hot milk comes out of
the main dispenser.
The milk temperature is too high. Good milk froth can
only be achieved when cold milk (below 50°F/10°C)
is used.
Check the temperature of the milk.
The main dispenser with integrated Cappuccinatore
is not correctly fitted and is taking in air. Or the
spouts are blocked.
Check whether the main dispenser is correctly
assembled. Make sure that all parts are tightly
connected to one another.
If necessary, clean the main dispenser.
The milk pipework, connections, or the intake tube
on the milk flask are blocked.
Clean all parts thoroughly.
The steam jet on the main dispenser has a blockage.
Push the cleaning brush a maximum of 1cm into
the steam jet.
Clean the steam jet with the cleaning brush.