Operating Instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Important instructions for use
- Machine description
- Controls and indicators
- Operation
- Miele@home
- Before first use
- Filling the water tank
- Filling the coffee bean container
- Switching on and off
- Cup heating
- Adjusting the coffee dispensers to the cup height
- Preparing beverages
- Expert Mode
- Grinder setting
- Parameters
- Profiles
- MobileStart
- Settings
- Cleaning and care
- Overview of cleaning intervals
- Clean by hand or in dishwasher
- Unsuitable cleaning agents
- Drip tray and grounds container
- Cleaning the drip tray cover
- Water container
- Removing and cleaning the water container filter
- Dismantling and cleaning the main dispenser
- Cleaning the steam jet
- Cleaning the milk pipework and rinse valve
- Cleaning the milk siphon
- Cleaning the milk flask
- Bean container and ground coffee chute
- Cleaning the casing
- Accessing the Maintenance menu
- _
- Rinsing the milk pipework
- Cleaning the milk pipework (maintenance program)
- Degreasing the brew unit and cleaning the interior
- Descaling the appliance
- Frequently Asked Questions
- Transport
- Service and warranty
- Accessories
- Saving energy
- Electrical connection
- Installation
- Appliance dimensions
- Technical data
Preparing beverages
33
First attach the connecting piece to
the long stainless steel tube. Make
sure that the slanted end of the
stainless steel tube is pointing
downward.
Attach the rinse valve to the
connecting piece.
Open the milk carton and dip the milk
siphon into the milk. Place the milk
carton to the right next to the coffee
machine.
Connect the milk pipework to the
aperture in the main dispenser.
Tip: Rinse the milk siphon under
running water after use.
The milk flask
depending on model: CM6360,
CM6560
Milk is not cooled in the milk flask.
For high-quality milk froth, always
use cold milk (<50°F/10°C).
a
Connecting piece
b
Lid
c
Seal
d
Stainless steel tube
e
Glass
Preparing the milk flask
Insert the connecting piece into the
lid from above until everything sits
flush.
Connect the stainless steel tube to
the inside of the lid. Make sure that
the slanted end of the stainless steel
tube is pointing downward.
Fill the milk flask with milk up to a
maximum of 3/4" (2cm) below the
rim. Seal the milk flask with the lid.