User manual

en
66
When to replace the battery in the ra-
dio-control handle
Change the battery approximately every
18 months. One 3V battery (CR2032)
is required.
The vacuum cleaner can still be used
when the battery has run out or if
there is no battery fitted.
 Switch the vacuum cleaner on using
the On/Off footswitch (Fig. 24).
The standby indicator on the vacuum
cleaner will light up yellow.
 Press the restart button on the va-
cuum cleaner (Fig. 43).
The vacuum cleaner can continue to be
used, but only at maximum suction
power.
 Keep batteries out of the reach
of children.
A swallowed battery can cause injury
and even death. Even flat batteries
can still be dangerous. If you suspect
a child has swallowed a battery, seek
medical advice immediately*. Exam-
ine devices and make sure the bat-
tery compartment is correctly se-
cured, e.g. that the screw or other
mechanical fastener is tightened. Do
not use if compartment is not secure.
* Australia: Poisons Information
Centre, Tel. 13 11 26;
NZ: National Poisons Centre,
Tel. [phone]
How to change the battery in the ra-
dio-control handle (Fig. 44)
 Undo the screw on the battery com-
partment cover using a cross-tip
screwdriver and then remove the
cover.
 Replace the battery with a new one.
Make sure the polarity is correct.
 Replace the cover and tighten the
screw back up again.
 Dispose of the old battery in a muni-
cipal recycling facility.
When to replace the battery in the
LED handle
Replace the batteries when necessary.
3 1.5V batteries (AAA) are required.
How to change the battery in the LED
handle (Fig. 06+07)
 Loosen the screw on the cover.
 Press in the sides of the cover to re-
lease the retainers and remove the
cover.
 Take out the battery holder and in-
sert the 3 batteries supplied. Make
sure the polarity is correct.
 Refit the battery holder. Arrows are
marked on the battery holder and
battery compartment as a fitting aid.
They should point in the same direc-
tion.
 Replace the cover and tighten the
screw back up again.
Replacing the thread lifters
(Fig. 45+46)
(not possible on EcoTeQ Plus floor-
heads)